VIENNA WINDOW SHADES

Important:

• Precise width and length measurements are critical. Fabric width cannot be altered after the shading is fabricated.
• Please use a metal tape measure for accuracy from home to factory.
• The headrail must be installed perfectly level and installed evenly to ensure smooth operation. On an Inside Mount, it is recommended that you check to see that the mounting surface is level and consistent. If your soffit needs to be leveled, this should be done before measuring.

Length Considerations
Elite will fabricate your window shading to the exact length ordered, when the vanes are in the open (or view-through) position. When the vanes are rotated to the closed position, the shading will become 3/8" longer.

When closed on an inside mount, raised, a slight puckering can occur on the lowermost sheer section because of the contact with the sill. To compensate, slightly raise the shading until the rail begins to lift off the window sill.

If preferred, Vienna™ can be ordered 3/8" less than the window opening's measured length. In this case, the bottom rail will be positioned 3/8" above the sill when the vanes are in the open position. (See diagram at right). Rotating the vanes closed will cause the bottom rail to touch the window sill, closing any space.

Side By Side Alignment
When Vienna Window Shades are installed side by side, cell alignment can be guaranteed within 1/4" only if:

• The shades are the same colour and ordered at the same time.
• The sum of the widths of all shades needing alignment is less than 102".
• Side by side alignment must be specified when the order is placed.