Features and Components
Basic Shutter Information
Panels
Frames
Size Specifications
Track Systems
Measuring
Cleaning/Warranty

BACK TO PRODUCTS

Hanging Strip

The fixed hanging strip is a piece of composite wood that is attached directly to the wall on opposite sides of the opening. The shutter panels are mounted to these pieces with wrap hinges. Hinges do not come pre-attached to the fixed hanging strip due to issues with alignment.
Spacer Block: Spacer block is recommended when using hanging strip to block light leakage along the top and bottom of the shutter. Spacer block is available in composite wood and in 100% wood. Composite wood is standard. If preferred, 100% wood light stop must be specified at the time the order is placed.

T-Posts
The T-post is a versatile structural component inserted vertically into shutter frames to separate shutter sections and allow for the placement of more panels within the same window opening. The T-post is designed to blend beautifully with each Richwood® Shutter-Lite frame design. Panels can be hinged to T-posts in the same manner they are hinged to a frame. Panel widths must be specified so T-posts are properly spaced for the panel configuration ordered. To order unequal panel widths within the same window, T-posts must be incorporated into the panel configuration. To specify T-post placement follow the directions below:

T-Post Placement (figure at left)

1. Measure the inside width and height in three places. Use the smallest or largest measurements depending on the frame you will be using.
2. Consider the deductions or additions for your chosen shutter or frame.
3. Note the number of panels, hinge style and hinge pattern.
4. From left edge of frame, indicate measurement to:
   Point A - Centre of first T-Post
   Point B - Centre of second T-Post, etc.